Any aftermarket turbo will spool "slower" than your stocker. If you flat out mat it to the floor the HX35 you have will spool faster than the...
The SPS62 will fit your needs quite well. It's good for 525hp as I recall. The next step is a pretty good jump and runs you up over 650hp as I...
There is no safety like that, but I would suspect that when the engine rolled over the fuel system starved and shut the engine down before any...
The fun thing with Diesel is if it only takes XXX ammount of fuel to run 60mph down the road, even with bigger injectors it only takes XXX...
I'd recommend giving them a call. Even with your fuel line routing you shouldn't be pulling the pressure that low.
You have a fuel drain back issue on the suction side of the lift pump. It is probably the fuel supply and return lines. They are rubber lines...
Running just a genaric Garrett or Holset turbo won't give you the performance you are looking for. There are MANY turbos out there right now that...
I believe that one was all AL.
I've wondered about that. Keep us posted on how the company treats you when you try to get that warrantied.
We are located in Coon Rapids MN. (just moving into a new shop) Edge Comp with those injectors and a SPS 62 should put you in that range, but...
Sounds like you didn't fill the truck enough when you did the Amsoil change.
If you are still, running the stock turbo you are no where near 500hp. 50psi is 14psi more than the turbo was designed to produce. 36psi is the...
Yes I did, sorry I was in a hurry when I typed that in. I personally prefer Fire Rings. In my opinion you are just weakining a stock gasket...
A1 Studs are made for Haisley Machine to their specifications. An O-ring uses a groove cut in the head with a stainless steel wire tapped into...
Well 2 things... Diesel Power magazine hasn't been around that long. As far as $4000 for a tranny... ehh I doubt it would actually handle that...
Well it depends on your power goals. Anything over about 400-450hp... especially if your towing, I'd recommend doing O-rings or Fire rings. This...
a 700hp Ford for $4000? I'm sorry but it's impossible.
45-50 is where I have seen head bolts streach. I won't even start to tell you the headgasket issues I've seen..... I am the master of desaster...
700hp.... Full billet Goerends, with all the nessissary parts... installed... I'll have to crunch some numbers but $6000 seems ballpark depending...
That injection pump won't tell you injection pressure. But it will tell you timing. New doesn't always mean good, especially with...
Separate names with a comma.
